Such is the case with the guide rod on the Springfield Armory TRP Operator.
It comes with a full-length guide rod, but I prefer a GI guide rod in my 1911 pistols.
[Be sure to see all of thenew TRP pistols.]
The author shows the standard G.I. guide rod he uses to demonstrate how to swap out your TRP full-length guide rod.
There are few things easier to do on the Springfield TRP, or any gun for that matter.
This is a critical safety measure I cant stress enough.
An accidental discharge can be catastrophic.
The author made a take down tool for his TRP using a paper clip.
You will need only one part for this: a new GI length guide rod.
This standard length rod can be purchased virtually anywhere including the Springfield Armory store.
it’s possible for you to also get nice aftermarket parts from places like Dawson Precision and Wilson Combat.
The arrow points to the hole in the TRP guide rod where you will need to slide in your paperclip.
Now, lets talk about tools.
You wont need a specialized kit for this job.
Springfield Armory uses a solid, 1-piece guide rod instead of those janky designs that some companies prefer.
For this swap, the author used the OEM plug. However, you can purchase an aftermarket one as well.
Fortunately, Springfield uses the superior design.
c’mon and thank you.
Believe it or not, a simple paper clip can be your best friend here.
Its used to hold the recoil spring in place during disassembly.
This is the only tool you need and will complete the setup.
Double check to see to it your pistol is unloaded safety first, always when handling firearms.
Lock the slide back on your Springfield Armory TRP.
This will expose a small hole in the guide rod just forward of the pistol frames dust cover.
Slide the short end of the paper clip into the hole.
Now, match up and remove the slide stop.
It should be aligned to do so with the slide resting against the paperclip.
Its straightforward, but requires a bit of care.
Push the barrel back, but do not venture to remove it.
Gently push the guide rod assembly to the rear and out of the slide.
With a firm grip on the guide rod assembly, depress the plug.
This is under spring pressure, so check that you have a good grip.
Then allow the plug to carefully move forward and release the spring pressure.
you’re free to now set the full length guide rod to the side.
However, keep the other parts handy, as you will use them when reassembling the 1911.
In the next section, well discuss the reassembly process.
Reassembly
Now that weve disassembled the Springfield Armory TRP, lets get it reassembled correctly.
Its important to point out that well be using the GI guide rod and recoil spring this time.
First, insert the GI rod into one end of the recoil spring.
Now, take the factory plug and slide it into its forward position in the slide.
Once there insert the free end of the spring into it.
With the new guide rod is seated, keep one hand curled over the recoil spring to stabilize it.
Align the slide rails on the guns frame to the slide and gently push it into position.
Insert the slide stop and lock the slide to the rear.
The assembly process is now complete.
However, this doesnt impact the function of the pistol in any way.
You could potentially find a reverse plug without a hole if it bothers you aesthetically.
Dont worry about it.
It doesnt impact the guns performance.
In fact, the absence of the guide rod makes disassembly easier.
If youre a stickler for aesthetics, you could find a reverse plug without a hole.
Regarding shooting performance, I havent noticed any significant changes.
Your TRP should be ready for normal shooting at the range.
Well, thats about it, folks!
Remember, these modifications can greatly enhance your firearms performance.
Always stay safe and adhere to all gun handling procedures.
Dont be afraid to tinker with your firearm its all part of the thrilling journey of gun ownership.
Happy shooting, everyone!
Go to forum
